Stepped Headphone Stand

I have designed a simple headphone rest that is compatible with basically all over the head headphones. It has a stepped base design. Personally I would recommend using ironing. However I use Bambu's Slicer so yours make be different so select ironing to your like so long as it wont interfere with tolerances near the cutouts. I used 30% ironing speed and 20% flow on mine. This model is designed to be layed flat in certain ways to reduce the amount of supports required. Only one section should require supports and that is the long pins on the tall piece that your headphones rests on no matter what version. I will have a fully sliced and oriented picture below for you to reference(it will be in photos). If you are using the one without the extension just disregard the two extra pieces in the top right of the slicer photo. All tolerances are .1mm and will have a tight fit that can support a lot on weight. If you have any questions just leave a comment. Note: in Bambu labs slicer I used a 10% gyroid infill, just encase you use the Bambu Slicer! :D