Coffin Candy Box (First 5 Makes get a FREE prize See description!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print-in-place vampire coffin candy box. Single color, no supports. Features a 5-knuckle hinge & snapping fang latch.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 49
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Autumn & Halloween
- Licencja
- Creative Commons — Attribution
🎁 FIRST 5 MAKES GET A FREE CUSTOM DESIGN! 🎁
Want something custom designed just for you? I’m rewarding the first 5 creators who print this model and upload a photo of their Make!
Here is how to claim your custom design:
Print this model and upload a photo of your Make to this page.
Leave a comment describing exactly what you want me to design for you.
The Rules:
📐 Realistic & Printable: Keep it physically possible to model and 3D print.
⚖ Under 100g: The final design must use less than 100 grams of filament.
🏷 Get Credited: Once finished, I will post the design on my profile and tag your username for permanent attribution!
Only 5 slots available—happy printing! 🚀
I USED GLOW IN THE DARK FILAMENT PLA
A pocket-sized vampire coffin that prints in one piece, in one color, with no supports. Pop it off the bed, crack the hinge free, and it's ready to fill with candy.
What moves
- Print-in-place hinge. A 5-knuckle hinge with a captive pin swings the lid open about 180°. The bores have pointed tops so they don't sag, and the radial and axial clearance is 0.5 mm.
- Bite-shut fang latch. A flexible tab on the foot of the lid snaps over a ridge on the box, so the coffin "bites" itself shut. To open it, pull the fangs outward.
Size: 52 × 105 mm when closed, 28 mm tall. The print plate is 52 × 205 mm.
Print settings
- Material: PLA or PETG, single color (orange, black, purple or glow-in-the-dark all look good)
- Layer height: 0.2 mm, with a 0.4 mm nozzle
- Walls: 3 perimeters. 15% infill is plenty.
- Supports: none. Brim: none.
- Orientation: as provided, with both halves open-side up. The engraved lid art goes face-down on the bed. A smooth PEI sheet gives a glossy lid, and a textured sheet gives a stone-like finish.
- Elephant-foot compensation: turn it on (about 0.2 mm). This keeps the hinge gaps from fusing on the first layer.
- If your bed is smaller than 205 mm in Y, rotate the part 45° on the plate.
After printing
1. Leave the part on the bed to cool, then remove it.
2. Gently swing the lid back and forth a few times to break the hinge free. If it's stiff, a few small open-close wiggles will loosen it.
3. Fold the lid over and press the foot end down until the fang latch clicks.
4. Fill it with candy!
