Woody Faceplate for MODULITH Drawers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Faceplate for MODULITH Drawers (formerly known as GEN2) with plywood inlay.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
You have organized your workshop with the outstanding MODULITH drawers?
You want to move on to your living space, but your beloved does not want to look at plastic boxes?
You are searching for a high wife acceptance factor design?
Don't look any further, this is Woody, the high WAF faceplate for the MODULITH system (formerly known as GEN2). Form and function combined for any place in life.
Woody is a faceplate with an inlay made from 4 mm plywood. Supported sizes:
2W 1U
2W 1.5U
2W 2U
See the PDFs for drafts for cutting the plywood sheets. Deduct 0.5 to 1 mm for your cuts. The pocket depth is 5 mm, this creates a shadow gap to compensate for slight irregularities (the 1U example pictured was the prototype and had no shadow gap, note the difference).
A small printable router jig for the rounded corners is available. I also added SVGs for laser cutting - untested, as I don't have access to a laser cutter. Use the faceplate as a drilling jig to drill the screw holes for the handle. There are also straight corner versions, in case you have neither a router table nor a laser cutter.
Inlays shown here are made from beech plywood and have been treated with a mixture of bee wax and linseed oil. Plates are printed with PLA. Handles used are here.