1 / 7
A combined Popup servo mount and cover. — zdjęcie 1
1 / 7

A combined Popup servo mount and cover.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a Popup servo mount which includes an integrated cover.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
5
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

This servo mount is similar to my original pop up mount but in this case it combines the tilting feature within a complete assembly which mounts on the surface of an airframe making it suitable for deeper pocket depths.

It can also be fixed into the outer frame which is usually glued between 2 adjacent wing ribs, this results in a flush top surface and is a very firm way of mounting

It is designed around the Towerpro 9g SG90 servo.

As with the original mount, if a servo needs to be replaced, or the servo arm needs to be repositioned then the servo can be tilted up for access.

The whole assembly will fit into a 47 x 47 x 12.0 deep pocket and the servo can then be replaced by simply removing the 2, M2 clamp screws, tilting the servo assembly upwards and removing the servo.

The pocket depth can be greater than 12mm but not less.

If the outer frame is used then you will need a 13 mm recess depth, I have included the .f3d file so that it can be modified to fit between the wing ribs.

Print Settings

  • Printer  used Bambu Lab  P1S

No rafts

Supports

0.2 mm resolution

Solid infil

Print settings for the Servo Surface Mount.
I found that a bed temperature of 60 degrees helped to prevent warping.
Both parts are printed flat on the bed using supports for the fixed frame but they are not needed for the tilting part.
Use the mirror feature to produce for the opposite wing.

Post-Printing

Assembly instructions for the Servo combi Mount.
Cut off a 46 mm long piece of 2 mm dia piano wire to act as the pivot, I used a Dremel cut-off wheel for this task.
Assemble both parts to the 2 mm pivot and check that everything works smoothly with a servo mounted on the lugs.
Clamp both parts together with 2 M2 servo screws.
The Combi Mount is now ready for use.

Tagi