1 / 1
GMKtec nucbox k11 Modular 6× SSD Holder – Homelab Storage Rack — zdjęcie 1

GMKtec nucbox k11 Modular 6× SSD Holder – Homelab Storage Rack

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Raid Tower

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
30
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Description

This project is a modular, 3D-printable storage rack designed to hold up to six 2.5-inch SATA SSDs in a compact homelab setup.

The holder is designed for use with Intel SSDs, including the Intel SSDSC2BX800G4R, and is intended for a setup built around a GMKtec NucBox K11 mini PC.

The modular construction uses 3D-printed brackets and M4 threaded rods to create a stacked storage rack. The threaded rods and nuts allow the assembly to be adjusted and secured mechanically.

Features

  • Holds up to 6 × 2.5-inch SATA SSDs

  • Modular, stacked design

  • Adjustable assembly using M4 threaded rods and nuts

  • 3D-printable components

  • Suitable for homelab, NAS and storage-server projects

  • Designed with easy assembly and maintenance in mind

Required Hardware

  • 3D-printed holder components

  • 4 × M4 threaded rods (approximately 200 mm; adjust to the final design)

  • M4 nuts and washers

  • M3 screws for securing the SSDs, where required by the printed design

Check the dimensions of your SSDs and the printed parts before assembly. Screw lengths must be suitable for the mounting points and must not extend too far into the SSD housing.

Printing Recommendations

Suggested starting settings:

  • Material: PETG or PLA

  • Layer height: 0.20 mm

  • Infill: 20–30%

  • Supports: Only where required by the geometry

  • Perimeters: 3–4

These are suggested settings, not experimentally verified print settings. Adjust them to your printer and the geometry of the individual parts.

Assembly

  1. Print all required holder components.

  2. Insert the M4 threaded rods through the designated mounting holes.

  3. Secure the brackets using M4 nuts and washers.

  4. Install the SSDs using suitable mounting screws.

  5. Check stability, cable clearance and ventilation before operating the system.

Notes

This is a DIY homelab storage project. The holder is a mechanical mounting solution and does not provide SATA connectivity, power distribution or data protection.

Please verify compatibility with your specific SSDs, enclosure and mounting arrangement before use.

If you make improvements or adapt the design to your own setup, feel free to share your makes and modifications!

Tags

SSD Storage Homelab NAS Intel SSD GMKtec 2.5 inch Modular Server Computer