Radial Engine
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Radial Engine that I designed, check out the main description!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Radial Engine
What are the dimensions, size of this engine?
It is ~45*45*12, (lenght, width, height).
The engine has a total of 18 individual parts.
The engine can be scaled up/down just make sure that the tolerances will fit.
What are the printing settings?
Layer height: reccomended 0.20mm.
Filament: PLA or PETG
Speed: reccomended normal.
Infill: reccomended 5% (more than that is useless), infill pattern does not matter however I use gyroid.
Supports: whereever there are overhangs. (Exactly these parts: flywheel, master rod, piston, piston body).
Rafts/brims: not needed.
Correct orientation show on the image below.
Assembly instructions:
Put the flywheel into the crankshaft base.
Put the master rod on the flywheel.
Place all of the rods (4 of them), onto the master rod.
Put all of the pistons on the master rods (all 5 of them, even the one that is not shown on this image, [next image]).
Now put the piston bodies on the crankshaft body, (you can use glue if neccassary).
And now you are done! Enjoy your radial engine!
