SOLDR 1x2 Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
There are variations with division into 4 segments or without spacers at all. The clicking lid is attached to the box.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 7
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Vital details regarding print settings are that lid should have 9-10 bottom layers to make a strong connection between two main rectangles and that your slicer should notice small top brims on the front side of the box. They make achieving "Clicking" sealing easier. If your box does not seal shut with the click - try softening sides with weak flame and then adjust them a little. It may take a few attempts, though last batches were consistent off the bed. I tested with wall generator "Arachne" and with brims for both parts.
The lid is attached to the box with a piece of filament pushed into the common throughout hole. No supports should be needed - as hole has "V" shape on top.
Also I think only two magnets on opposite sides are enough, but I left all four grooves just in case.