1 / 8
Nvidia Quadro P4000 80mm fan converter plate — zdjęcie 1
1 / 8

Nvidia Quadro P4000 80mm fan converter plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a replacement plate for Nvidia Quadro P4000, to add a high static pressure 80mm fan to replace the blower fan.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
18
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This is a replacement plate for Nvidia Quadro P4000, to add a 80mm fan to replace the blower fan.
Be sure to use a high static pressure fan, I have used Artic P8 slim pwm pst. This is a 15mm version and perfect for this.
Other 25mm alternative versions are Artic P8 pmw pst, Artic P8 Max and Noctua NF-A8 pwm.
Use 4 fan screws to mount the fan from the backside of the plate.
Remove the blower fan. I reused the 3 fan screws and put M2 nut on them to seal the screw holes, don't know if this is needed, but I think it looked better.
Uses the original shroud screws.
Connect fan to motherboard header or a fan control hub, and control it with software like fancontrol and you get silent and perfect control of your fan curve.

It needs to be printed in a material that can handle high temps, so minimum PETG
I have printed it with 0.2 layer height, 5 in wall , top and bottom layers and 40% infill.
And of course you need your prints to be scaled perfect to get it to fit perfect.

I did a 3DMark Timespy run before and after. The GPU score was 4769 before with blower fan and 4764 with the new fan setup, both run had temps between 82°C and 83°C
The noise level difference is huge, its now not a problem to have my computer on the desk right beside me anymore.

Tagi