Ender 5 Plus BTT PiTFT50 Mount

I created a mounting bracket for the BigTreeTech PiTFT50 screen to fit on an Ender 5 Plus. The design is in 2 parts (plus the retaining clips). Because of the way it's designed, you can still mount the Pi on the back of the display if you wish.

Use the mounting hardware that came with the display to mount the display to the bracket and to optionally mount the Pi to the back. Use M3 screws for the retaining clips. They should self thread into the holes but you can use heat insets if you wish.

Print the bezel face down without supports. Print the mounting bracket flat side down with supports. The supports are tiny but they are needed to prevent the recessed mounting holes from forming badly. You can then easily remove the support material with a pair of needle nose pliers or just pry them out with a small flathead screwdriver.

Update 2022-02-12

This design is slightly refined. I've also added the retaining clip. Print Settings ==============

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm layer height

Infill:

Filament: Hatchbox PLA Black

Category: 3D Printer Parts