Split GT2 Pulley 30T for M8 Threaded Rod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Split GT2 30T pulley for M8 rod: two identical halves, slide-in L-joint, hex nut drive. Mount without removing rod.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A two-piece GT2 timing pulley that can be mounted on and removed from an M8 threaded rod without pulling the rod out of its bearings. Both halves are identical, so you print the same part twice.
I designed it for a hand-crank belt drive that extends and retracts a sliding bed frame. It works for any low-speed belt drive on a M8 rod.
How it works
The two halves join with an L-shaped tongue and groove along the axis. One half sits on the rod, and the other slides in axially.
Torque is transmitted form-fit: a hex collar on one end fits over a standard M8 nut. A second nut on the opposite side locks the pulley axially and clamps the halves together.
The bore is plain Ø 8.0 mm, with no printed thread.
Specifications
GT2, 30 teeth, pitch diameter 19.10 mm (60 mm belt travel per revolution)
For 10 mm wide GT2 belts (11 mm tooth width)
Flanges Ø 23 mm, 45° chamfered for support-free printing
Hex socket for M8 nut (13 mm across flats), 5 mm deep
Overall length 22.4 mm
The split line runs through two tooth gaps, so no seam lies on a tooth tip
Hardware
2 × M8 self-locking nuts (DIN 982)
Optional: Loctite 243 on the locking nut
Assembly
Thread the first M8 nut onto the rod to the desired position.
Place half A on the rod with its hex collar over the nut. Align one nut corner with the split plane.
Place half B on the rod next to half A, offset axially. Slide it in until both halves are flush. About 18 mm of free rod length is needed for this.
Thread the second nut against the flange on the opposite side and tighten it.
To remove the pulley, loosen the locking nut, slide half B out, and lift both halves off.
Print settings
Orientation: standing, axis vertical, as provided in the 3MF. No supports.
Layer height 0.15 mm, 0.4 mm nozzle
Wall generator Arachne. With Classic, the 0.45 mm tooth tips may come out incomplete or be dropped entirely.
Seam: aligned or painted into the outer corner of the groove. Avoid random seams, since seam blobs on the tongue or groove make sliding stiff.
Elephant foot compensation ~0.15 mm
Material: PETG recommended for permanent use. PLA works for test fits but the hook is more brittle.
Tips
Print one pair first and check the fit. The halves should slide together by hand and stay closed at the seam.
A light coat of PTFE or silicone spray on the tongue helps. Avoid oil.
Designed in Solid Edge. STL and Bambu Studio 3MF are included.