Internal and external HEPA 13 filter holder for Flashforge Creator 5 pro

A tool-free holder that lets you use the Bambu Lab P2S / X2D external exhaust fan HEPA filter (100 × 130 mm) on a Flashforge Creator 5. Stick it on with double-sided tape, then snap the filter in.

⚠ Note: Seems Bambu Lab sells two kinds of filters for the P2S / X2D. Make sure you’re using the external exhaust fan HEPA filter, not the internal activated-carbon filter.

Features

• Spring fingers on both short ends. Filters aren’t all exactly the same length, so the fingers flex to hold anything from about 128 to 132 mm firmly.

• Grip teeth on the sides hold the filter so it doesn’t slide around.

• Finger cutouts on the long sides make it easy to pull the filter out when you replace it.

• Tape wings on both ends give a flat surface for double-sided tape. No screws or drilling on your Creator 5.

Fits

• Printer: Flashforge Creator 5, on either the internal circulation fan or the external ventilation fan

• Filter: Bambu Lab P2S / X2D external exhaust fan HEPA filter, 100 × 130 mm

Install

1. Put double-sided tape on the underside of both wings.

2. Press the holder firmly over the fan you want to filter, either the internal circulation fan or the external ventilation fan. Clean the surface first so the tape sticks well.

3. Push the filter in until it snaps past the fingers.

4. To swap filters, grab it at the finger cutouts and pull it out.

⚠ External ventilation fan: in this position the holder gets in the way of the Creator 5’s stock spool holder. Either run without the stock spool holder or swap in a custom one.