Springfield Kuna mag holder for 10mm bolts. And has rounded corners.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It holds 4 mags for the kuna and has rounded corners to help with lifting. And works with 10mm bolts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I really like the original design but I like to be able to use magnets for most things like this and I was having lifting issues I have all ways had some issues with sharp corners on my A1. So I rounded the corners and still lifted a little bit but about 90% better. I used 10mm x 1/2 inch bolts with a couple washers on the back. And it also should work with wafer head screws at least the 3/4 long ones I have. I also made the holes flat for my needs the holes are 5.35mm wide and work with 10mm bolts. The sunk in parts were the bolt or screw head rests is 13mm wide.