1 / 3
Plant Saucer with Drainage Ribs – Pot Stays Dry, 12 & 16 cm, No Supports — zdjęcie 1
1 / 3

Plant Saucer with Drainage Ribs – Pot Stays Dry, 12 & 16 cm, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Solid plant saucer: the pot stands on 8 ribs, water drains into channels. 12 & 16 cm, no supports.

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

A simple, solid saucer for small and medium plant pots. The pot stands on 8 radial ribs instead of sitting in the water: excess water from the drainage hole runs down the channels between the ribs into the ring channel along the rim, so the roots don't stay soaked and the bottom of the pot can breathe.

  • Pot stays out of the water: 8 ribs, 2.5 mm high, keep the pot base above the collected water.

  • Channels lead the water away: open grooves between the ribs + a 5 mm ring channel along the rim.

  • Solid and watertight: full 1.2 mm floor (6 layers), 2.2 mm rim, 13 mm high, rounded inner corner for easy cleaning.

  • Two sizes: inner Ø118 mm (pots ~12 cm) and Ø158 mm (pots ~16 cm). Outer Ø122 / Ø162 mm.

  • Prints without supports: flat on the bed, vertical rim and ribs – 0 overhangs. The 3MF is ready to print.

  • Tip: for a fully watertight saucer print with 3+ walls; PETG is the best choice for permanent use with water.

Print settings

  • Orientation: flat on the bed (as in the 3MF / STL).

  • 0.20 mm layer. PLA or PETG.

  • Bambu Lab A1, PLA, 0.20 mm (2 walls, 15% infill): 12 cm – 47 min / 33.4 g, 16 cm – 1 h 05 min / 52.6 g.

Designed from scratch by bezbajzlu.

Tagi