Whirlpool Dishwasher Basket Wheel and Mount / Clip Assembly
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
wheel and mount
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Open Community License v1.1 + General Attribution v1
Replacement basket wheel and mounting clip assembly specifically designed for Whirlpool dishwashers (also compatible with many Indesit, Hotpoint-Ariston, Bauknecht, and Ignis models).
If the original plastic clips or wheels on your dishwasher rack have snapped or degraded over time, this 2-piece printable assembly replaces both the axle clip (mount) and the rolling wheel to get your rack sliding smoothly again.
Design Features:
2-piece modular design (wheel + mounting clip).
Reinforced clip and axle geometry for better resistance to heavy rack loads.
Compatibility: Fits standard wire basket frames on Whirlpool and Whirlpool-group dishwashers.
Print Settings Recommendations:
Material: PETG, ABS/ASA, or PCTG is mandatory. Do NOT use PLA, as it will deform under hot water cycles (60°C+) and harsh detergent conditions.
Wall Loops / Perimeters: 4–5 walls for maximum structural strength on the snap-fit clip.
Infill: 50–100% (Gyroid or Grid).
Supports: Recommended for the clip axle area depending on your print orientation.
