ReedArc - Small Fluted Vase for Dried Stems | 110 mm

ReedArc is a small decorative vase for dried stems and small dry arrangements on a shelf or desk. Eight broad flutes follow a gentle twist and soften into a smooth circular rim and base. The complete walls and base are included in the model.

Dimensions

- Height: 110 mm.

- Base and rim: 46 mm nominal diameter.

- Open mouth and straight cylindrical cavity: 40 mm nominal diameter.

- Internal depth: 107 mm above a continuous 3 mm base.

- The fluted exterior varies in width; its maximum outside diameter is approximately 59.6 mm.

The sidewall is intentionally variable in thickness. Digital checks of the exported mesh confirm a conservative sidewall separation greater than 2.99 mm. This is a CAD check, not a guarantee of printed dimensions.

Printing

Print upright with the flat base on the bed. Use ordinary multi-perimeter printing: the walls are already modelled. Do not enable spiral/vase mode. Suggested starting point: PLA, 0.4 mm nozzle, 0.2 mm layer height, 3 perimeters, 5 bottom/top solid layers and 15% infill. Choose a suitable profile for your own printer and material. After importing the geometry-only 3MF, arrange or centre the model on the chosen bed and inspect the preview. No printer-specific G-code is supplied.

Verification status

The STL and 3MF were checked for one closed, consistently oriented solid, a continuous floor, open mouth, wall separation and modest outer slopes. Offline slicing completed with an isolated generic PLA profile; the top opening and solid bottom were reviewed. Physical printing, finished dimensions, stability with stems and water retention have not yet been tested. Intended for dry decorative use.

Files and customization

STL, geometry-only 3MF in millimetres, original parametric Python source and bilingual instructions. The source exposes height, cavity size, flute count, amplitude and twist. Any changes require fresh geometry and slicing checks. The 3MF contains the same geometry as the STL with an initial placement offset; it has no printer or material preset.

Images

The images are CAD renders of the actual exported STL. The two viewpoints show the same model. The cut-section image explains the complete printable geometry; it is not a separate part. Colours are illustrative. No photograph of a physical print is shown.

Original design by MARGRAF ITALY. Creative Commons Attribution 4.0 International.

Italiano

Piccolo vaso decorativo per steli secchi, alto 110 mm, con otto scanalature leggermente ritorte che sfumano nella base e nel bordo lisci. Apertura nominale 40 mm, fondo continuo 3 mm. Pareti gia modellate: usare la stampa ordinaria con piu perimetri, senza modalita vaso/spirale. Geometria e slicing verificati digitalmente; prova fisica, stabilita e tenuta all'acqua non ancora verificate. Le immagini sono render del file effettivo e una sezione esplicativa. Uso previsto a secco.