SPKR Sub + Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
30Hz Beast utilizing Ultimax UMII8-22
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This thing is measuring down to 30Hz nicely then falling off after that..
YOU NEED A BIGGER PRINTER! 260x260x260 PRINTABLE area required for this.
(Someone send me a E180HE-44 7" and ill make one that fits on a 253 plate)
5 walls 35% TPMS-D
Elegoo PLA-CF was used in mine.
Order a 10pack of filament........
I did NOT have to sand to fit only for epoxying and the port hole seem needed a touch for the tube to fit through, there is a bit of tolerance, .1, to allow the epoxy to fill a tiny bit of space since I am hoping its stiffer than the printed plastics.
Female Bananas: https://www.amazon.com/dp/B0GD5PTVH2?ref=ppx_yo2ov_dt_b_fed_asin_title
Epoxy every face that touches after a quick sanding to aid the bonding, then tappy tapp it together, I used a rubber mallet, ran a rag on the inside for drips and outside had a nice seam.