TMC2130 RAMPS/Re-ARM Adapter PCB
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I upgraded my AM8's electronics stack from an Arduino Mega to a Re-ARM a while back. The Re-ARM doesn't connect…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 241
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I upgraded my AM8's electronics stack from an Arduino Mega to a Re-ARM a while back.* The Re-ARM doesn't connect anything to several of the AUX2 pins, so the usual approach to run TMC2130s is to commandeer the pins for the Ethernet interface and use them for software SPI. This adapter board makes running TMC2130s on a RAMPS/Re-ARM stack simpler to wire.
This is a remix of https://www.thingiverse.com/thing:3337519, which was done in DipTrace. I first converted it to EAGLE format, then imported that into KiCad. The result of that conversion is in the master branch in this project's Git repo:
https://gitlab.com/salfter/DisplayTMCAdapter/
Select the rearm branch to get this remix.
A 3D render of the board is uploaded here to satisfy requirements. There's obviously not much point in printing it. The zipfile under “Other Files” is a Git snapshot you can download with the KiCad files, gerbers, etc.
* I've since replaced the Re-ARM stack on my AM8 with an SKR 1.4 Turbo without having gotten around to producing this myself. This is posted with the hope that it might be useful for someone else running this hardware combination.
Category: 3D Printer Accessories