Mitten Dryer for Towel Radiators
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hook it on a towel radiator, slide a wet mitten over the finger: warm air rises inside. Dry by morning. No supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
Wet mittens on a radiator usually lie flat and are still damp in the morning. This hook holds them upright and open over a towel radiator: warm air rises into the mitten and dries the inside too.
How to use it
Hook it over a horizontal tube of a towel radiator (heated towel rail). The stem rests against the tube, so the weight of a wet mitten keeps it in place.
Slide the mitten or glove over the finger, cuff down.
Print one per mitten: the 3MF "paire" files put two on one plate.
Sizes
Three versions for Ø 22, 25 and 28 mm tubes, the common towel radiator sizes. Measure your tube and pick the closest one (a calliper or a strip of paper around the tube: circumference ÷ 3.14).
About 90 × 95 × 16 mm, 33 cm³. The finger is 16 × 16 mm and 85 mm long, fine for child and adult mittens and for most gloves.
Not for flat panel radiators: they have no tube to hook on.
Print settings
PETG or ASA. A radiator runs at 60–70 °C and PLA softens and bends.
Prints lying flat on its side, no supports, 0.2 mm layers, 4 perimeters, 25 % infill. The layers follow the load, so the hook is strong.
Safety
Do not cover a radiator's thermostat or block an electric towel rail's heating element. Check your radiator's maximum surface temperature for your filament.
First prints are being tested. If the hook is loose or tight on your tube, tell me and I will add a size.
Designed with AI assistance (parametric Python script, manifold3d).
En français
Séchoir à moufles pour sèche-serviettes : le crochet s'accroche sur un tube horizontal (Ø 22, 25 ou 28 mm), la moufle s'enfile sur le doigt, poignet en bas, et l'air chaud monte à l'intérieur. Sèche pour le lendemain matin. À imprimer en PETG ou ASA (le PLA ramollit sur un radiateur), à plat, sans supports. Un séchoir par moufle : les fichiers « paire » en mettent deux sur un plateau.