Hypercube Shaft Endstops
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are simple rings that clamp onto the shafts of the CoreXY mechanism to set travel limits when using the…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
These are simple rings that clamp onto the shafts of the CoreXY mechanism to set travel limits when using the StallGuard feature of TMC2130 drivers instead of limit switches or other endstops. Print two of each to make a set suitable for a Hypercube 300 (10-mm carbon-fiber tubes on X, 8-mm steel rods on Y). Use M3x6 (?) screws and M3 nuts to secure the two halves to each shaft. Modify and re-render the OpenSCAD files if you need different diameters.
The X-axis endstop is 10 mm i/d and the Y-axis endstop is 8 mm i/d; these correspond to the dimensions for the X-axis carbon-fiber tubes and Y-axis steel rods specified for the Hypercube 300. Change and rerender the OpenSCAD files if you need different diameters.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
40%
Filament: eSun PLA+ fire-engine red
Category: 3D Printer Parts