CoralBoard Container

This is my first ever Printables project!!!

This is a simple no hardware required (Except for maybe mounting) enclosure for the Synaptics Coralboard SL. The lid on the Coral Container just rests in place and has a hole in it for expansion through use of the GPIO connector. Other relevant I/O are accessible from the outside, such as the USB port for accessories, and the USB type C port which is used to deliver power and if in part of a larger array, connect it to a host device.

Printing Instructions

• USE SUPPORTS!!! (it makes it easier, and if you use tree they literally fall right off, though I havent tested it without supports, I'm Scared.)

• USE PETG or other higher temp resistant plastics, as I didn't check the thermal output, but the Synaptics page said it was rated for operation between 0 and 70 degrees Celsius, so to be safe I used PETG

• Layer height does not matter, so use however tall you feel comfortable with, however the side ventilation will not look as good, the higher the layer height is.

• Choose what configuration, if you want to mount it (Coral_Container_Mounted) or not (Coral_Container), but nevertheless you do need a top (Coral_Container_Top)

• This can be printed in as small as a 120x 120 build plate if you want to use the mounted one, but I would recommend at least a 180 x 180 so you do not have to run two print jobs.

Thanks for looking at my first Printables Project.