Broom & Mop Holder with Spring Jaws - Wall Mount, 22-28 mm Handles, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Broom & mop wall holder with spring jaws for 22-28 mm handles. 2 sizes, 2 screws, prints without supports.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Standard Digital File License
A sturdy wall holder for broom, mop and garden tool handles. Push the handle in from the front: two long spring jaws open, snap around it and press it against a flat, rigid back stop. The handle is gripped from both sides, so the broom hangs where you put it and comes out with a simple pull.
Spring jaws, not a tight ring: long 34–36 mm jaws flex in the layer plane (strong direction), so they don't crack. Strain in PLA stays at about 1.5 %.
Grips a range of handles: size S for 22–25 mm handles, size L for 25–28 mm. The thinnest handle in the range is still pressed by 1 mm per side.
Rounded lips: smooth entry, 16.5 mm (S) / 19.8 mm (L) opening between the lips.
Solid mounting: 2 screws Ø4–4.5 mm through the middle block, 90° countersinks. The screwdriver passes between the jaws. Use 4×50 mm screws + 6 mm wall plugs.
Prints without supports: lying on its side (profile on the bed), only the Ø5 screw holes bridge. The 3MF is ready to print.
Size: S 43 × 32 × 28 mm, L 44 × 35 × 28 mm.
Print settings
Orientation: lying on the side, as in the 3MF / STL (jaws flex along the layers – do not rotate).
0.20 mm layer. PLA or PETG (PETG for wet rooms / garage).
Bambu Lab A1, PLA, 0.20 mm (2 walls, 15% infill): S 22–25 mm – 33 min / 13.2 g, L 25–28 mm – 35 min / 14.0 g.
Designed from scratch by bezbajzlu.