Angled Wall Mount for Unifi G6 Turret Camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fully rotatable 22.5º wedge wall mount for a Ubiquiti Unifi G6 Turret Camera.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
In fitting a Unifi G6 Turret camera to the wall, I discovered that the view angle required was just beyond the camera's physical side-to-side adjustment. I created this mount to solve that problem.
The mount is in two parts:
A baseplate that provides the desired entry/exit angle for surface-mounted POE cables (up/down/left/right). Can be omitted if you are doing a cable through the wall installation.
A wedge part that sits on the baseplate and allows the entire camera body to be rotated in any direction at an angle of 22.5º.
Once the entry/exit and camera rotation are determined it is simply fixed to the wall with up to four screws. These secure the wedge to the wall trapping the baseplate in between.
The G6 Turret camera then fixes to the wedge with 4 short screws leaving all the usual camera adjustments available.
I printed my mount in ASA as it is outside on a south facing wall. PETG is a possibility depending upon your environment.
ps. If your POE cable is surface-mounted don't forget to pass it through the camera's mounting ring and this mount's wedge and baseplate slot before you screw the wedge part to the wall (see photo)!