Tescoma Ice Maker Replacement Lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacements lid for the Tescoma silicone ice maker with 8 large cubes.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 5
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Replacements lid for the Tescoma silicone ice maker with 8 large cubes. I snapped mine when removing it. And Tescoma sells no replacements!
🖨 Share your makes! 🖨
I'd love to see how this model turns out for you. A ❤ Like is also highly appreciated.
Food safety
While many filaments are food safe (check at the manufacturer site), 3D prints from them are usually not because of the print head materials. That being said, given this will be in contact with frozen water, not anything hot, I consider the risk fairly low. Use at your own risk.
How to print
Material
I recommend printing in PET-G because of mechanical properties and general food safety of many PET-G materials. PLA will likely snap.
Layers and perimeters
Nozzle: 0.4 mm
Layer height - other: 0.25, first: 0.2 (variable is even better, see the project file)
Perimeters: 3
Solid layers - Top: 3, Bottom: 3
Extra perimeter if needed
Detect bridging perimeters: Yes
Single perimeter on top surfaces: All top surfaces
Only one perimeter on first layers: Yes
Infill
I think I went a bit overboard with the infill. 15% Lightning would probably work too. Here is what I used originally:
Fill density: 15%
Fill pattern: Gyroid
Top/bottom fill pattern: Monotonic lines
Skirt and brim
No brim
Support material: None
Editing
Remixes are welcome. Especially the other lid shapes. The original model can be copied from OnShape.
Changelog
2026-10-28 - 1.0.0
Initial release