Elegoo H1 HT Dryer Bottom Filament Outlet Guide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Guide for the bottom rear outlet on the Elegoo H1 HT dryer to prevent snags and reduce the friction for printing
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 1
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I recently purchased the Elegoo H1 HT to go along with my CC2. Unfortunately I ran in to an issue whereby when using the bottom outlet, the canvas unit could not pull the filament through. When using the top outlet, due to how I have mounted my dryer unit, it would sometimes pull it over.
I wanted to use the bottom outlet to enable printing while drying, so designed this small part to be able to angle the filament towards the canvas unit.
This should work with other multi-colour systems and I have included the files for both left and right-hand pull, to keep the PTFE tube secure both if the unit is next to the left or right of the printer. The additional hexagon allows the PC4-M6 nut to screw in tight to the socket and provides additional support so as not to allow movement.
This resolved my issues and allows me to print any material straight from the dryer now.
It is my first upload, so I hope is helps someone else out.