1 / 5
Secretlab Magnus Pro Laptop Mount with Desk Lip — zdjęcie 1
1 / 5

Secretlab Magnus Pro Laptop Mount with Desk Lip

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Laptop mount for the Secretlab Magnus Pro with a lip that rests on the desk. Parametric remix, fits a 14" MacBook Pro.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
43
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Secretlab Magnus Pro Laptop Mount with Desk Lip

A laptop mount for the Secretlab Magnus Pro desk. It slides into the channel of the leg support like the original, and a lip on top rests on the desktop. Your laptop stands upright under the desk edge, out of the way.

This is a remix of the Secretlab Magnus Pro Laptop Mount by DancherBoi. I wanted the mount to sit more solidly and to fit my own laptop, so I rebuilt it as a parametric model and changed a few things along the way.

What's Different

  • Desk lip: A lip reaches about 30 mm over the desktop. The mount rests on the desk instead of only hanging in the channel, so it doesn't wobble.

  • Flush at the desk edge: The arm sits against the edge of the desktop with 0.5 mm of play.

  • Room for the desk's underside: The pocket between arm and head is wider and deeper, so it clears the bulge on the underside of the desktop.

  • Laptop slot: 18 mm wide, sized for my 14-inch MacBook Pro (M4 Pro, 2024). For a different laptop, change the slot in the source file (see below).

  • Screw notch: The notch at the end of the head is still there, it clears the screw in the channel.

Fit and Source Files

I designed and tested this on my own Magnus Pro, where it slides in snugly and sits without play. Desks and printers vary, so the source files are included: the parametric SolidCraft design (in the ZIP under other files) and a STEP file.

In the SolidCraft file every dimension is a named parameter. The ones you are most likely to change:

  • laptop_thickness and laptop_clearance for the laptop slot

  • desk_edge_clearance for the fit against the desk edge

  • lip_depth for how far the lip reaches over the desk

I have not tried it on the Magnus Pro XL, since I don't have one.

Printing

  • PETG

  • 0.24 mm layer height, 6 walls, 15 % infill, 5 top and bottom layers

  • Print it flat as provided, no supports, no brim

  • Textured PEI plate

Two ready-to-print projects with exactly these settings are included: a Bambu Studio project for the X1 Carbon and the Snapmaker Orca project for the Snapmaker U1 I printed my own mounts with.

Installation

Same as the original: take the plastic cap off the end of the leg support, slide the mounts into the channel and put the cap back on. The original recommends two or three mounts for a laptop. I use four.

Final Thoughts

If you print some, I would love to see them! Please post your makes so I can see how they look on your desk.

Happy printing!

Tagi