Double WAGO 221-412 Mount (2 variants)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screw mount for WAGO 221-412 wire splicers; supports 2 221-412 splicers on one mount, with 2 different orientations.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simply merged 2 of gltovar's model side-by-side to create a double-mount for keeping the WAGO splices for 2-wire cables together.
One version contains a side-by-side version, meant for the pairs coming in and going out from the same side; the blind hole for this one is a through-hole. The other version has the pair with rotational symmetry, for wires from opposing sides; the through-hole serves no purpose, and I cannot be arsed with removing it.
(Simulating wire entries and exits with jumper wire, for better visuals. Ignore the messy tape, the wires sprung the splicers and mounts up.)
Both versions keep the internal rectangular catches on both internal sides that help hold the splicer in place. These mounts – like the original – fit countersunk 3mm screws, though it's a bit of a tight fit.
(At one point I considered making one with the splicers mounted end-to-end, but I do not see where this wire arrangement can be useful. And mating 2 "belly-to-belly" left unsightly holes everywhere in the internal wall, despite it being a smaller mount; while its "screwability" would have been lost, it could have been glued down.)