1 / 2
SV08 Dual Screen Mod — zdjęcie 1
1 / 2

SV08 Dual Screen Mod

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bracket for the SV08, holds the factory screen and the official SV08 Klipper touchscreen

Ocena
0 / 5
Polubienia
2
Pobrania
2
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Simple design to allow you to print an addon bracket to place both your original factory monochrome LCD that comes with the SV08, and the official SV08 Klipper screen. Now they are at a good angle for a desk or table.

I recommend printing this in PETG, if you have an enclosure then ASA or ABS would be ideal, but its not a huge deal if you don't have an enclosure.

I modeled it with 4 walls, inside to outside wall order, 40% crosshatch infill, prints in 3 1/2 hours, uses 180 grams, no supports, .18mm optimized, could work fine with .20, and probably be a good bit faster.

Tagi