Magnetic Floor Sweeper (Metal Pickup)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A rolling magnetic strip with handle to roll across floor to pick up metal debris.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I made this using the Harbor Freight 18" magnetic tool strip. I made mine 8" (200mm) by cutting it into. To remove the center magnet, strip the paper from it and put little drops of Acetone or similar solvent around magnet and start moving magnet around to loosen. I was unable to get it out, but the next step did. With a hacksaw or other cutting tool, barely cut through the metal all around and separate. The magnet comes out easily without breaking it. Clean up cut end and add hole like original. Caution: Any solvent around the magnet when moving it around can cause it to squirt up in your face, wear eye and face protection.
Hardware:
M5 x 35 or 40mm screw for handle pivot
M5 x 16mm screw, two for wheels
M5 x 12mm screw and nuts, two to mount block to magnet frame (washer optional)
M5 set screw or short screw to secure sliding block in place
5mm hew nut to be imbedded in knob
M3 x 8mm screw, four to fasten sliding block and pivot block together
Screw together the slide on block and the pivot block with the 3mm screws. The slide on block assembly needs to be put on before the wheels. Use set screw or short screw to snug the block assembly to the magnet strip center. Screw the end blocks on with bushing and wheel assembly. Bushing flange is against the block, and a screw holds the wheel on, a washer may be necessary if the screw head is too small. Insert pivot and add screw and knob. Add pole, adjust handle and tighten to desired angle. If you have a straight pole you will need to modify pivot to fit or make your own. The pivot is 20mm diameter by 19.8mm across with a 5.4mm hole.
To insert nut into knob, stop print after 14mm. Pivot block has center hole for screw not shown in picture. To make other diameter wheel it is 7mm thick with an 8.1mm hole. Print slide on and pivot blocks on side. This gives it layer strength where needed. I used generic black and red PLA with 0.20 layer, 20% infill, 3 walls. Printed on SparkX i7 printer and designed using Layerling for the first time.