Ender 3S1 Linear Rod Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Linear rod Uprade X-Y-Z Axis
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed a lot with these mods and I had no issus yet. The pinter feels a lot more rigid now, and the quality also improved.
I printed most parts fom ASA and a few are made out of PLA+, all of them were printed on my Ender 3S1. On some parts you need support, on others there is no need, but do it as you like. I put a picture of my print orientation online so you can see how I did it.
The build volume is a little bit smaler than original!!
x:215mm (5mm less than original)
z:265mm (5mm less than original)
You need to put two nuts on top of each other for tne new end stop, otherwise it cant reach the end stop position. Please see the last picture
Matials I Used:
x-axis:
12x m3x8mm, and 8x m3 heat set insert
2x m3x12mm
2x m2.5x18mm!!!
a few m3 scews for the bearing block and the extruder mounting plate
2x 8mm rod, 350mm long
1x LM8UU (two each side)
1x LM8LUU (long version, because i had some alignment issues when using two short ones)
y-axis:
8x m3x12mm, and 8x m3 heat set insert
8x m5x12mm, and 8x m5 t-nut
2x 8mm rod, 350mm long
4x LM8UU (two each side)
z-axis:
16x m5x12mm, and 16x m5 t-nut
2x 8mm rod, 450mm long
4x LM8UU (two each side)
I hope I did not forget anything:)
In case I did please let me know.