Under-Table Purse & Backpack Hook – Clip-On, No Screws, 18 / 25 mm Tabletops

Keep your bag off the floor in a café, office or at home. Slide the clip onto the edge of the table and hang your purse, backpack or shopping bag on the hook underneath. No screws, no tape – take it off and put it in your pocket when you leave.

• Clip-on, no tools: the C-clip slides over the table edge; a 0.8 mm bump on the upper jaw presses it to the tabletop so it does not slide around.

• Two sizes: for 18 mm tabletops (most furniture boards) and for 25 mm tabletops (desks, kitchen tables).

• Deep J hook: 20 mm wide pocket with rounded R6 corners (straps don't get creased), 16 mm entry from the front – fits flat straps, round handles and backpack loops up to ~15 mm.

• Made for the load: 6 mm spine and lower arm, 22 mm wide; the bag pulls along the printed layers, not across them.

• Prints without supports: lying on its side (profile on the bed), only vertical walls. The 3MF is ready to print.

• Size: 18 mm version 48 × 66 × 22 mm, 25 mm version 48 × 73 × 22 mm.

Print settings

• Orientation: lying on the side, as in the 3MF / STL (do not stand it up – it would print weak across the layers).

• 0.20 mm layer, PLA or PETG (PETG for a bit more springiness).

• Bambu Lab A1, PLA, 0.20 mm (2 walls, 15% infill): 18 mm – 34 min / 14.6 g, 25 mm – 36 min / 15.0 g.

Tip: for heavy bags place the hook close to a table leg; on thin glass or very glossy tops add a small piece of rubber/felt tape inside the clip.

Designed from scratch by bezbajzlu.