Ender 3 V3 SE Nozzle Camera Mount (W202012HD Module)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact 2-piece nozzle camera mount for Ender 3 V3 SE using the W202012HD camera module. Attaches to extruder shield.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 27
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a two-piece nozzle camera mount designed for the Ender 3 V3 SE utilizing the W202012HD camera module. It attaches directly to the front of the extruder shield for a close-up view of your print nozzle. I hooked mine up to a Raspberry Pi so I can monitor and stream print feeds from anywhere via my website, it has quickly become my favorite printer mod!
I currently don't have an integrated cable guide, as my printer is in an enclosure and I use a taped USB extension overhead to keep the cord elevated away from the print bed.
Hardware Requirements
2 x M3 x 10mm screws (flat head or cross/Phillips head) to replace the stock screws on the extruder shield.
1x M5 x 20mm screw with lock nut to attach the camera mount to the base and keep it securely in place.
IMPORTANT WARNINGS & DISCLAIMERS
LED Wiring Notice:
The W202012HD module shares a single resistor for all three onboard LEDs.
Do NOT solder only one LED per side: without all three LEDs in circuit to share the current, single LEDs will burn out immediately (learned this the hard way before tracing the PCB!).
Heat Exposure & Temperature Testing:
I attached a temperature sensor to the side of my extruder shield and completed several prints with PETG to test thermal effects on the module.
Note: While it hasn't damaged mine and I feel confident keeping it installed long-term, I cannot guarantee heat won't affect or damage your specific camera module. Monitor your hardware during initial prints!
Clearance Disclaimer:
Use at your own discretion.
This design has been thoroughly checked to clear the stock Ender 3 V3 SE printer frame components.
Caution with tall/multi-part prints: I cannot guarantee clearance against printed parts if you are printing tall multi-part setups across the bed or experimenting with non-planar 3D printing. Always double-check your preview and clearance before running a print!
Shoutout to @gbgarage_582100 for the module mount design, although if you're using LEDs, you can omit the front lid.