Bicycle Handlebar Phone Holder

Bicycle Handlebar Phone Holder

Story:

Ever since I bought my bike, I've felt like something was missing while riding: a place to keep my phone so I could switch my music quickly. So, in about 2 hrs, I designed this phone holder in Fusion 360, a parametric design so it can be adjusted to fit different handlebars or phones :)

Features:

• M4 bolt and nut clamp: Drop an M4 nut into the cutout, insert a bolt through the hole, and tighten it to your handlebars.

• Holes so you can tie your phone down with, e.g., a Velcro strip, so it cannot fall out of the holder.

• A failsafe hole enabling you to tie it to the handlebars, ensuring that, in the (very) unfortunate event that the clamp (or hardware securing it) fails, the holder (and your phone) remains attached.

• A charging port hole, so you can keep charging the phone on the go (even better with a dynamo-powered charger).

• A bike drawing <3

• Text that shows you where to plug the charger, so you never miss the hole :D

What's included:

• a STEP file of the holder

• an STL file of the holder (for a Samsung S24 Ultra, about 83mm in width)

• a parametric Fusion 360 (f3d) source file

• G-Code for Bambu Lab A1

What's not included:

• Phone

• Bike

• M4 bolt and nut

• Filament (roughly 95g needed, out of which 10g for supports)

Assembly:

• Print the holder and remove supports

• Insert (and optionally glue) an M4 nut into the pre-cut slot

• Install on the handlebar, making sure it is tight and secure.

• Insert the phone and go ride the bike :)

Disclaimer:

I am not liable for any damages that might occur while using this design. I have not tested it yet; use at your own discretion.