Right side charging port cover for Renault Scenic / Megane e-tech
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a completely redesigned of the design of Von Plaf. This cover is printable with PLA or PETG. Not TPU.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Car manufactures use a plunger for locking the charge flap. The mechanism is reused from ICE vehicles. Where fuel flaps stay only a few minutes open per week, charge flaps are exposed to all kinds of weather from lets say 30 minutes to even more then 12 hours per day! All EV brands are known for having problems with it. So reusing this fuel flap design for EV's is a complete failure. I had to let my Megane plunger replace after only 2 years for €200. And I don't want it to be replaced again. So I wanted to protect the plunger against the weather.
This design is completely different from the original designs here mentioned. Only the two holes and the curve for the hinge are from the original, since these measures are equal. The original TPU designs seem almost watertight. My aim was not to be waterproof, but more like splash proof. Because of the hole for the buttons, the design is no more than IP 22, I think. But it does not have to be more than that.
The design has only 2 purposes: keep most of the snow out and protect the plunger against dirt, dust and water. If it keeps 95% of the rain, dirt and dust out, I'm happy. :-) It is not meant to improve the water tightness of the charge port itself. I presume car manufacturers know what they are doing (although they don't know how to create a weather proof locking mechanism).
Just use PLA or PETG. I know PETG is more robust against UV, but I used PLA. If it breaks apart, within 4 hours I have a new one. And if it deforms, cracks or breaks too often, I can always go for PETG.
But DO use support. The locking mechanism have some edges that needs some tiny support (see photo). If your printer can print with an overhang angle of 60° then that is the only support needed.
The rest of the settings are standard.
After my last print I made a modification, because I had a gap at the bottom side of the cover. If you print it, let me know if it still needs adaptations. I used a hair dryer for a few minutes to heat the surroundings of charge port hole to bend it a little bit in that area, so I didn't have to reprint it all over again. Insert the charge plug in the hole, when you want to bend it!