1 / 1
MLAstro SAL-33 Pier Handle — zdjęcie 1

MLAstro SAL-33 Pier Handle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A handle for the MLAstro SAL-33 Pier. Locks into place using the cutouts already provided.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
48
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A handle that attaches to the pre-existing cutouts of the MLAstro SAL-33 Pier.

I printed using ASA, seems very robust but obviously risk is with you so check before you put any weight on it! Carrying the SAL-33 with a scope attached is not recommended by MLAstro, so I would also advise against that.

You'll need to print the handle, outer ring, 1 x top cut out, 2 x cut out and 3 x inners.  Then add m5 nuts where needed (I v gently hammered them home) and m5 bolts to get it all together.

Feel free to remix and make it better, I am very much a novice so no doubt this could be modelled much better.

Tagi