MayAudio Hyacinth
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DIY Hifi Open-back Headphone using high quality 50mm drivers. Designed in Finland. Made for pure sound quality.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hifi Open-back Headphone using high quality 50mm drivers.
The sound is very accurate to the 10dB tilt Diffuse Field target on a KB501x clone rig.
The goal of this headphone was to use more consistent materials than the MayAudio Sword, have better channel balance, and be more durable.
The sound is exceptionally accurate below 10 kHz and has some added warmth in the low end subbass region for more body.
Made to work with any headband, headphone diameter is 84.5 mm.
Part | Link |
|---|---|
3D printable headband | |
Yokes for the 3D printable headband (Satyr 2 Yoke Left + Right in the NEW one) | |
Earpads | |
Driver (buy two) | |
Heat inserts | |
Tuning paper (buy Y3 2pcs) | |
Sockets | |
Internal wires | |
M3 screw set (you need 12 20mm screws + 4 10mm screws if you print the 3D printable headband) | |
PETG Filament (use any decent PETG, do not use PLA) | |
Cable (2x3.5mm) |
Designed in Finland.
Made for pure sound quality.
Join our discord server: https://discord.gg/FM5Sw2YNhX
Support us on kofi: https://ko-fi.com/maya224696