Pleated blind cord shoe, replacement part
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for the small plastic shoe at the bottom of a pleated blind.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 6
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
The cord shoe on one of my pleated blinds snapped, and I couldn’t find the part on its own anywhere. So I measured the old one, drew it in Fusion and printed a new one. It holds the cord as well as the original did. It is a bit more fragile though. The comparison photo shows both.
The cord goes in through the slot at the front, into the cord hole, and then between the two mushroom-shaped jaws, which pinch it in place. The side walls and the cross bar keep the shoe seated in the rail.
Pleated blinds from different brands use slightly different parts, so compare the dimension drawing with your old shoe or your rail before printing.
I could not find the manufacturer of mine. I think it was from Bauhaus (german hardware store).
Dimensions (mm)
Overall (W × L × H) | 11.75 × 27.11 × 6.3 |
Base thickness | 1.4 |
Inner width between walls | 9.75 |
Wall thickness | 1.0 |
Wall height, front / rear | 3.0 / 5.0 |
Cross bar (L × W) | 7.5 × 1.7 |
Clamp jaws (Ø × H) | 5.4 × 6.3 |
Gap between jaws | 2.0 |
Cord hole | 5.2 × 1.5 |
Cord slot | 0.8 |
Corner radius | 1.4 |
Print settings
Print it flat on the base plate. It doesn’t need supports.
Layer height 0.12 to 0.16 mm, because the features are small.
100 % infill.
PETG or ASA if the window gets a lot of sun. PLA works but can soften in direct sunlight.
It takes about 1 g of filament and a few minutes to print.