1 / 3
UniFi ViewPort Wall Mount — Reinforced, Recessed Screws — zdjęcie 1
1 / 3

UniFi ViewPort Wall Mount — Reinforced, Recessed Screws

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Reinforced ViewPort mount with recessed screw heads, extra fit clearance, and less support. Tested in PETG.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A reinforced wall mount for the UniFi Protect ViewPort, with recessed screw heads and a slightly roomier retaining loop. Thisrevision was successfully printed in black PETG and physically fit-tested.

Original design and attribution

Based on “Unifi Viewport Wall Mount” by MTNEARZ on MakerWorld. Thank you to MTNEARZ for the original bracket design. The original and this remix are licensed under Creative Commons Attribution–NonCommercial–ShareAlike 4.0 International. Remix by bbum (Bill Bumgarner), with AI assistance for the geometry revisions.

What changed

  • 6 mm backplate, increased from 2 mm.

  • Loop walls reinforced outward to approximately 3 mm.

  • Two flat-bottom screw-head recesses: 12 mm diameter × 3.5 mm deep, with 5.5 mm through holes and 2.5 mm backing beneath each head.

  • Opening enlarged by 1 mm overall in width and approximately 1 mm in height.

  • Loop sides extend to the backplate and bed, eliminating the lower unsupported shoulders. The loop roof still needs support.

Fit and hardware

Inside opening is approximately 49.50 × 33.97 mm; the loop band is 20 mm wide. Overall size is approximately 55.62 × 131.16 × 43.08 mm. Print at 100% scale; STL units are millimeters.

The recesses suit flat-bottom screw heads approximately 1/8 inch (3.175 mm) tall. Check your hardware against the stated dimensions: full-height M5 socket-cap heads may be too tall.

Tested PETG settings

  • Snapmaker U1, standard 0.4 mm nozzle, SUNLU black PETG.

  • 0.20 mm layers, 4 walls, 8 top / 5 bottom shell layers, 15% gyroid.

  • 245°C nozzle / 80°C bed; maximum volumetric flow 8 mm³/s.

  • Outer walls 60 mm/s, inner walls 100 mm/s, first layer 30 mm/s.

  • Tree/organic supports from the build plate only: 0.24 mm top gap, 0.35 mm XY gap, 2 interface layers, 0.5 mm interface spacing.

  • 5 mm auto brim. Broad flat backplate on the bed, loop upright; the supplied STL is already oriented this way.

Slice for your own printer and filament. The tested slice estimated 1 h 39 min and 31.1 g including supports; this is an estimate, not a measured print duration.

Tagi