Prusa magnifying glass, Prusa Display Lupe
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
magnifying glass for Prusa Display, Lupe für das Prusa Display
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Prusa is using a smal screen und the contrast, especialy orange on white is not the best for my old eyes. I was loocking in the internet if there is the possibility to change the screen to a bigger on, but found nothing. So desingned an holder that fits to the display and added an cheep magnifying glass from Amazon. The holder is designed with SolidCraft.
But you have to make some changes to the MK4S.
- print the 20mm feet, printet with TPU or use a 20mm thick pice of wood
- print the magnifying glass holder (I use PLA)
- you need 4 M6 hammer-head bolt
- you need 4 M6x15 hex socket screw
- Remove the original feet
- install the printet feet
- remove the 4 hex socket screw on the back of the frame to loosen the display
- remove, on the front plate where the display is installed, on the right side the lower left screw
- remove, on the front plate where the display is installed, on the left side the lower right screw (from my point of view, to remove this 2 screws will be no problem for the stability of the printer)
- install the display with 2 screws in the lower holes of the frame and the upper at the display
- cut the magnifying glass to 108x61 mm
- install the magnifying glass into the holder
- clip the holder to the display; the longer clip is up
On my MK4S, and printet in PLA it works fine. Not sure if there are differences to other or newer displays.