Yard Force Classic 500 - 203mm adapter, 3mm nut-seat floors [EXPERIMENTAL]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Experimental remix with enlarged closed nut bosses, radial ribs and 3 mm floors. Not validated for rotating use.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 1
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Thank you, PlasticPusher, for sharing the original Yard Force Classic 500 6xBlade Adapter and mounting information. Based on the 203 mm no-fins version.
WHY THIS REMIX
A previously printed adapter failed locally around one blade attachment during mowing; the blade and fastener were lost. An impact is suspected but unconfirmed. This prompted a study of the nut seats; it does not establish a defect in the original or prove this remix prevents failure.
CHANGES
Six closed upper nut bosses enlarged by up to approximately 1.4 mm where space permits. Six radial ribs on the nut side add up to approximately 1.8 mm above the surrounding surface, starting beyond a 78 mm radius. Outside diameter remains 203 mm.
The plastic floor under each nut increases from approximately 2.4 to 3.0 mm. The nut support plane rises 0.6 mm and pocket depth decreases accordingly. Hole XY positions and blade-side geometry remain unchanged. No washers or insertion slots.
TEST STATUS AND HARDWARE
Mesh closure and 3.0 mm floor coordinates digitally checked. Mechanical strength, actual fastener engagement, rotor clearance, blade pivot freedom, balance and fastener retention have not been verified. The 3.0 mm revision has not yet been re-sliced. Added material is not proof of resistance to pull-through, impact or fatigue. Experimental geometry, not a validated repair or an approved Yard Force replacement part.
The owner reports plain M4 nuts; this is not a recommendation to substitute them for the self-locking nuts specified by the original designer. The anti-loosening arrangement requires independent assessment.
FILES
STL and geometry-only 3MF, without personal printer settings or machine start/end commands. Dimensions in millimetres. AI-assisted geometry changes.
Original: https://www.printables.com/model/1032310-yard-force-classic-500-6xblade-adapter
Original author: PlasticPusher. Thanks again for making the design available to the community.
License: Creative Commons Attribution-NonCommercial 4.0. https://creativecommons.org/licenses/by-nc/4.0/
