Modular Marker Organizer (Copic Organizer)

Hi,

this is a modular storage for Copic Markers but also should fit a wide range of different Markers, Pens and whatever can fit in a 17x17mm square hole. 

It comes in 2 sizes, one 100m wide for 5 Markers an one with 200mm for 10 Markers. 

They both have a height of 20mm and are 120mm long. Also included are a base and topshelf in both widths, The Base puts it in an slight angle and the tops levels it out.

You can build it as wide as you wish, the two witdhs allows to stack them like bricks. To avoid sliding each 100mm lenght has 2 pins that interlock with the matching holes in the part below, here you have again two options, either to put them straight on top or to put them just a bit forward to to adjust for the backwards angle an achieve a  vertical stacking.

Printparameters doesn't matter that much, I use 2 Walls, 2 Top- and Bottomlayers, 15% gyroid infill, these results in ~75g of filament for evere 100mm in width includig a few grams for the supports. 

Have fun printing and painting and let me know if you have any ideas what to add or if you encounter a problem with them.