Splatoon Ink Tank Backpack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Backpack ink tank for Splatoon costume
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 9
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution
Top and bottom for a Splatoon Ink Tank. Prints were made with 0.1mm layers and 0.4mm extruder on a MK4 with MMU.
The tank itself was made by just printing cylinders in Vase Mode with a 0.8mm extruder and cutting holes for backpack strap rings. Bending an acrylic or polycarbonate sheet could be used for increased durability and a clearer tank. It was designed for a 20in circumfrence since that seemed to be a common size for plastic sheets.
FreeCAD file included in case you need to adjust the size, but you may need to tweak it a bit if you do; it is only somewhat using parameters.
Other items I used (from the sewing/fabric section of Hobby Lobby):
Four rectangular rings for backpack straps
Two backpack strap adjusters
Two 60in pieces of nylon webbing
As well as a couple of pieces of weatherstrip foam from a hardware store for padding.
The gun in the images was printed using this model: