Samsung wireless charging dock for charger model EP-PG920l
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Jimmer Jammer's remix, of rsavell's design for a wireless charging dock. The original design was…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 68
- Wydruki
- 1
- Wyświetlenia
- 511
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is a remix of Jimmer Jammer's remix, of rsavell's design for a wireless charging dock.
The original design was awesome, but like others, my Samsung S8 plus with a thick SPEC case on did not fit in the original. So I opted for Jimmer Jammer's iteration.
However I preferred that the micro USB cable be plugged in at the bottom of the dock, rather than at the top where the wire basically hangs in mid air (see second image for USB plug location) - as such, I cut out a slot in the back of the model to have enough clearance for the micro USB plug. This doesn't affect structural integrity at all and in my opinion, makes for a more sleek design.
Some might feel that such a sharp angle will damage the micro USB cable, and maybe that's true, but if you're like me, you probably have a million of these lying around.
NOTES:
1 - Not ALL micro USB cables will fit here, you need one with a smallish plug section.
2 - This dock works with the EP-PG920l Samsung wireless charger that came with the S6 and possibly S7 (not fast charge) - haven't tested with other chargers.
3 - Print it standing up on its base (just like it will stand when completed) with no supports needed.
4 - I set my seam to random, but try hide them at the back of any face parts if you can.
Print Settings
Printer:
BIQU B1
Rafts:
No
Supports:
No
Resolution:
0.16 (Doesn't matter)
Infill:
20% gradual
Filament:
Sunlu PLA
Blue-Grey
Category: Mobile Phone