Table Saw Alignment Jig for Neoteck Dial Indicator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Baseplate for table saw fence/blade alignment jig which uses a digital dial indicator
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This is an alternative baseplate for Honza's Table Saw Blade Alignment Jig. It has been modified to support 57mm diameter dial indicators (Neoteck brand). It has also been lengthened to allow the plunger tip to reach the blade from either miter slot on the Dewalt DWE7491 (the 10" version of the DWE7485).
Design notes:
The mounting stem opening (plunger side) has a tight-fit 8 mm opening. The opposite side (plunger lifter side) has a clearance-fit 8 mm opening. Verify this works as intended on your indicator before use, otherwise the plunger lifter may catch and give misleading results.
The in-use image below shows an earlier prototype with a much larger probe stem opening. I've reprinted the mounting ring to test the fit, but the prototype works well enough for me that I haven't felt the need to reprint the whole thing.
This model is compatible with the original knobs and T-track runner.