1 / 3
Dell Optiplex 5060/7040 SFF Internal Dual 3.5 inch HDD Mount — zdjęcie 1
1 / 3

Dell Optiplex 5060/7040 SFF Internal Dual 3.5 inch HDD Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fits 2 Slim 3.5in HDD in Optiplex 5060 SFF Screw Requirements are a little odd Please print in PETG

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
1
Wyświetlenia
49
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Public Domain

Fits 2 slim 3.5inch drive without any bulging from the side panel.

You might be able to fit full thickness 3.5inch drives but with a lot of bulging since the slim drives just perfectly fit.

The bottom screw where the hdd lock would normally be uses a m3 screw which is different from all the other motherboard screws

Also airflow with the drives stacked directly on top of each other could make temperature a problem.

If your computer is not a Optiplex 5060 SFF there is no guarantee this will fit/work

I had to bend back a metal piece at the top and break off the middle plastic clip on the front panel.

I printed it upside down with tree supports and it works well

You need some form of right angled or very short screwdriver to get the inside screws.

Highly recommended you print in PETG or something else that is temperature resistant

Was created with Claude AI Opus 5.5

Tagi