dr650 rse turn signal rubber replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print replaces the rubber turn signal support that breaks down with time, print with support with 46° min angle…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 9
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This print replaces the rubber turn signal support that breaks down with time,print with support with 46° min angle (only the lower portion needs support). I printed them inTPU and used super glue to attach the strange original nut to it. I tested also PETG but the superglue failed probably beacause of vibration, with hard plastics you would have to use a soft adhesive like silicon. Avoid PLA as it probably won't survive the heat of the nearby exhaust in the back signals or the sun.
Category: 3D Printing