1 / 4
Nissan Leaf EM57 Drive Unit Gearbox and Inverter Terminal Covers for AZE0/ZE1 2013-2025 — zdjęcie 1
1 / 4

Nissan Leaf EM57 Drive Unit Gearbox and Inverter Terminal Covers for AZE0/ZE1 2013-2025

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Covers to prevent moisture/debris from entering a Nissan Leaf AZE0/ZE1 EM57 drive stack during storage.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
5
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I am planning to swap a Nissan Leaf AZE0 drive unit into a classic car sometime in the future, but it will be stored in a shed until that happens. The gearbox caps might fit all 2011-2025 AZE0/ZE1 Nissan Leafs, but the inverter terminal cover will probably only fit 13-25 vehicles.


Once you remove the PDU, the terminals for the inverter are exposed which can cause water and dust to get into critical high voltage hardware. You REALLY don't want moisture getting into the inverter, so the first cap is critical. The other two caps are to cover the gearbox outputs where the driveshafts go, hopefully keeping the fluid in and other stuff out. The left/right are different sizes so you will need one of each.

For material, I chose PETG. PLA will work fine as well, but I find that it can warp over time and might lose it's seal. I wouldn't use ABS/ASA since it tends to delaminate and probably won't be as effective at keeping moisture out.

If I end up taking the inverter off, I will design caps for that too and update this. The only change I'd make to the design is designing the gearbox caps to snap into the differential (like the driveshafts do) to keep them from falling out, since the seal alone doesn't to a great job of holding them in place.