Modular Reversable Clamp V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully 3d printed clamp meant to be as big as you want or as small as you need. Now with rubber feet for delicate project
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 98
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Based on commonly found bar and pipe clamps adjusted for 3d printing. Each of the clamp tubes adds 15cm of length to the clamp. Can be used as a clamp or reversed as an anti-clamp. Meant for light to medium clamping jobs. Working on a version that uses extruded aluminum as a tube for added rigidity.
Printing:
Note: not all parts are oriented correctly; adjust in the slicer for best printability/strength
Support: Most parts will need support, especially the clamp jaw and vise housing
Strength: Use as many walls as you think necessary; I used around 5 walls @.4mm.
Parts:
4x Clamp stop
1x Clamp vise housing
1x Vise foot
2x Clamp stop screw
1x Clamp vise screw
Clamp tube(print as many as you want)
1x Clamp Jaw
Assembly:
Clamp Jaw:
Thread vise screw through back hole all the way.
Position one clamp stop on each side of the screw, aligning the groove on the screw with the one on the stop
Unscrew the stop until it fully seats and both stops remain in contact with each other.
Clamp vise:
Repeat steps for Clamp Jaw
Screw vise screw through top of front hole.
Press fit foot onto screw
Clamp tube:
Screw 2 tubes together until seams align(may require wrenches if fit is poor)