1 / 3
H1+ for Alfa 868 Antenna
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of vascosim's remix of the original H1 case design by muzi.works to fit a Alfa 868 Antenna
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a quick remix of the H1+ case.
Unfortunately, supports will be needed for this one (you might want to block supports in areas where they aren’t needed).
A 5 cm U.FL-to-N-type connector fits nicely (remove the O-ring), but you should also be able to route longer ones inside the case.