World Trade Center Twin Towers Coin Bank – 1:700, 3-Part Sectional, Fully Detailed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A detailed 1:700 model of the original Twin Towers (1973–2001) as a coin bank. Each tower is about 60 cm tall
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Description
A tribute model of the original World Trade Center Twin Towers in New York, designed as a working coin bank.
Details
Scale 1:700. North Tower 596 mm to the roof (about 760 mm with antenna and base), South Tower 593 mm.
All 59 perimeter columns per facade, modelled like the original.
Recessed louvre bands at the mechanical floors (41–42, 75–76, 108–110).
Gothic-style arcade arches at the base.
Chamfered building corners, roof parapet, rooftop mechanical structures.
The South Tower has the observation deck walkway, the North Tower the removable antenna.
Both towers stand on one shared base plate in their original staggered arrangement.
Coin bank function
Coin slot in each roof, sized for 2 € coins and smaller.
The towers are hollow all the way down.
A flush, removable lid under each tower lets you empty it.
The inside of the roof slopes at 45° or steeper, so no supports and no long bridges are needed.
Assembly
Each section has a 14 mm square spigot (0.2 mm clearance) that slides into the section above. The base plate has the same spigots. Because the joints are square, the facade grooves line up automatically. The seams sit directly below the louvre bands, where they blend into the existing horizontal lines. With a full coin bank this tall, I recommend gluing the sections (CA gel or 2-part epoxy). You empty the bank from below anyway.
Print settings
Nozzle: 0.4 mm (no larger, or the facade grooves will be lost)
Layer height: 0.2 mm (0.16 mm for the antenna)
Walls: 3
Infill: 10–15 %
Supports: with
Orientation: all parts upright, as exported. Print the lids flat side down.
Material: PLA or PETG. A light grey or silver filament shows the facade detail best.
For the antenna, a brim and a slower speed help.
