Kabrio fingertip mouse mod for VXE R1 series (S SE SE+ R1 Pro MAX) ALL IN ONE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of jj000000's Kabrio mod which I made it compatible with all VXE R1 variants in one single shell.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The one to fit them all!
PLS follow jj000000's guides! And support his works:)
For R1 R1se R1se+ R1S(Nearlink) users, just print jj000000's original model and remember to like his great design.
This remix is mainly a temp-solution for R1 pro PCBs (MAX is the same R1 pro PCB) and for those who forgot which variant they have, follows CC BY-NC-SA 4.0.
Known issue: the VXE stock cable's typec connector is too short to charge it or use it as wired mouse properly, use a normal typec cable should be fine, but I'll fix it.

Fixed: With new design, now it's compatible with most paracord cables and fits well for using it as a wired mouse.
I made the sidewalls no holes but texturized, to make it easier to print on FDMs while maintaining the structural strength with minimum weight, this also makes using it without griptapes more acceptable.

Would recommend printing it with PLA or something lighter like ABS/PA12 if u can, resin prints look dope too.

PS: 1.PLS make sure u like this shape so much that u most likely won't revert it back to stock shell before cutting the part of sidebuttons' PCB sticking out poking ur palm, even though on stock shell 2 screws can still hold it tight, just think it through.
2.For Pro/MAX, U must at least cut the sidebuttons connector that would rub against battery cables, or cut them both/print sidebuttons separately for little bit of weight reduction.
3.Some 3395 lens are not hot fused with sensors, be careful, don‘t lose it or break it. Also remember to bag all your stock parts in one place in case u need them someday.
Printed it with reinforced PETG, 6.1 grams shell plus sidebuttons.
30 grams with 5 dot skates and R1 Pro MAX (500mah battery) internals.

